Electrical Engineer - Analog and Power Supply Design

Designs, develops, implements, and tests analog and power electronics for products and test equipment.  Researches and analyzes design approaches and parameters. Selects components and equipment based on analysis of specifications and reliability. Carefully plans and executes development efforts. Conducts verification testing and analyzes results.  Manages sub-contractor or vendor activities in support of product development.

 Apply now!

Duties

  • Working with a team to develop the electrical system requirements and architecture.
  • Circuit design, part selection, schematic entry, and performance analysis.
  • Hardware testing and troubleshooting.
  • Generates engineering drawings, test reports, work instructions etc.
  • Defining and managing sub-contracted activities.

Required Skills/Qualifications

MSEE degree OR a BSEE degree and 2+ years of electrical design experience. Good written and oral communication skills. Familiar with the principles of analog circuit design (filtering, resonance, ground loops, switching dynamics, loss calculations etc.). Experience testing and troubleshooting in a lab environment using common electrical test equipment (oscilloscope, signal generator, power supply, spectrum analyzer etc.). Able to maintain revision control on work products (software, drawings, bills of materials etc.). Able to track and report tasks against a project schedule. Able to investigate and establish the root cause of failure and prescribe corrective action. Able to follow a structured design & development process. Able to work with suppliers to manage sub-contracted activities. Experience developing electronics for high reliability products.

 

Preferred Skills/Qualifications

Experience performing product qualification and verification testing. Experience designing or testing switched-mode power supplies (SMPS). Familiar with the PCB fabrication and assembly process (data package generation, quoting, PCB fabrication, board assembly etc.). Experience designing circuits using Altium Designer CAD tool. Experience simulating circuits using OrCAD PSpice tool.

[NOTE: The above statements are intended to describe the general nature and level of work being performed by people assigned to this classification. They are not to be construed as an exhaustive list of all responsibilities, duties, and skills required of personnel so classified. All personnel may be required to perform duties outside of their normal responsibilities from time to time, as needed.]